Full Tear-Off and Disposal
We strip the old vinyl, aluminum, or wood siding down to the sheathing and haul it away. Dumpster, labor, and disposal are in the quote. You are not left with a pile of old panels in the driveway.
Every job is different, but a standard insulated vinyl siding installation covers the full exterior envelope, not just the panels. Here is what is included in a typical Akron quote, and what we price separately if your wall needs it.
We strip the old vinyl, aluminum, or wood siding down to the sheathing and haul it away. Dumpster, labor, and disposal are in the quote. You are not left with a pile of old panels in the driveway.
We check the sheathing for rot, pest damage, and soft spots, then replace what is failing. Minor repairs are included; large sections of rotted wood siding get priced as an add-on before we proceed.
House wrap goes on lapped and taped, with trim coil flashing at windows, doors, and penetrations. This is the water-management layer that keeps water infiltration from rotting the wall behind your new panels.
Insulated panels installed off a chalk line with nails centered in the slot so the vinyl can move. Corners, J-channel, and starter strips are set square, and every course is checked with a level.
We finish the roofline with matching soffit and fascia and trim out windows and doors. If your existing soffit is sound, we can leave it; if it is sagging or water-stained, we replace it in the same pass.
We magnet-sweep the lawn and beds for nails, load out debris, and walk the house with you. You get the workmanship warranty and the manufacturer registration confirmation before we leave.
Insulated Vinyl Siding Installation in Akron is the process of removing old cladding, repairing the sheathing underneath, then hanging vinyl panels with a bonded foam backing that adds an R-value layer to your exterior wall. The foam is glued to the panel at the factory, so you get insulation and siding in a single nail-down step instead of two separate trades. Panels go up with a siding nailer, set plumb off a chalk line, and lock into place with a 3/4-inch nail slot that lets the vinyl expand and contract through an Ohio summer-to-winter swing.
Most Akron homes we open up were built between 1915 and 1975, and the wall behind the old siding tells the story: rotted wood siding, dented aluminum siding, or vinyl that has been chalked and faded for two decades. Foam-backed panels buy you roughly R-2 to R-5 of added wall insulation, which matters when January lows sit near 20 degrees and wind pushes off the Cuyahoga Valley. If you have been searching for insulated vinyl siding company near me and getting thin answers, we walk the wall with you, show you the soft spots, and price the full tear-off.
A typical Akron insulated vinyl siding job runs two to five days depending on square footage, how much trim work is involved, and whether we find rot behind the old wall. Here is the sequence, start to finish.
Schedule
Call or book online — a real human picks up and confirms a 2-hour arrival window.
Diagnose
Licensed tech inspects on-site, then walks you through the cause and your options.
Fix
The job is completed to code and done right the first time — no shortcuts, no surprises.
Guarantee
Every job backed by a written workmanship warranty — and we stand behind it.
Siding Nailer
Drives nails to consistent depth without over-driving, which is what keeps the vinyl free to move in its slot.
Chalk Line and Level
Sets the first course dead level so every course above it stays straight across the full elevation.
Circular Saw and Tin Snips
Cuts panels to length and shapes trim around windows, doors, and corners without cracking the vinyl.
Siding Removal Tool and Pry Bar
Pulls interlocked panels and old cladding without tearing up the sheathing underneath.
Caulking Gun
Applies sealant at penetrations and trim joints where water would otherwise work its way behind the wall.
Scaffolding and Ladders
Keeps crews stable on two-story elevations so panel reveals stay consistent from grade to gable.
Tape Measure and Flashing
Layouts courses and laps window and door flashing so water sheds down and out, not into the wall.
Vinyl Siding Institute Installation Standards
We follow VSI nailing and clearance rules on every job, which is the standard manufacturers reference when a warranty claim comes up. Nails centered in the slot, panels free to move, proper clearance at corners and trim.
Shingle-Lap House Wrap
Wrap goes on lapped from the bottom up so each course sheds water over the one below. Seams get taped and penetrations get flashed, which turns the wrap into a real drainage plane instead of decoration.
EPA Lead-Safe Work Practices
On pre-1978 homes, which covers most of Akron's older neighborhoods, we contain the work area and handle painted debris under EPA Lead-Safe Certified procedures. Dust stays out of your yard and your air.
Manufacturer Warranty Registration
We register CertainTeed, Mastic, and Alside panels in your name with the correct documentation. An unregistered warranty is the reason a lot of faded siding never gets covered.
01
What we do: We document the impact damage, work from the adjuster's scope, and install insulated vinyl panels with matching trim. The foam backing handles future hail better than the aluminum did.
→ The claim covers most of the wall, and the homeowner upgrades to insulated panels for a modest out-of-pocket difference.
02
What we do: Full tear-off down to sheathing, rot repair around two windows, new house wrap and flashing, then foam-backed panels in a deep clapboard profile.
→ Upstairs rooms hold heat through January, and the trim detail matches the house's original look from the sidewalk.
03
What we do: We re-flash the back wall, correct the drainage that kept it wet, and re-side with insulated panels and new soffit. Nails go in centered so the vinyl floats.
→ No more streaks after two seasons, no panels lost in storms, and a heating bill roughly nine percent lower.
04
What we do: We quote standard vinyl and insulated vinyl side by side, show the cost difference, and let the owner pick. Insulated wins when the wall has no cavity insulation.
→ The owner gets a wall that survives student turnover and cuts the heating bill the tenant pays.
Akron sits in a freeze-thaw belt, and that shapes every siding decision we make. Winter lows drop near 20 degrees, summer highs push into the upper 80s, and the swing between them is what cracks cheap vinyl and pops tight-nailed panels. Lake-effect wind coming off the Cuyahoga Valley hits west and north elevations hardest, so those walls get extra attention on flashing and nail placement. Most of the housing stock here was built before 1975, which means we are usually working over old wood siding, dented aluminum siding, or vinyl that has been chalked and faded for years. We are EPA Lead-Safe Certified for that pre-1978 work. Ice dam damage at the soffit and fascia shows up every February, and we fix it in the same pass as the siding so you are not paying two crews. If you are pricing insulated vinyl siding replacement cost Akron homeowners actually pay, the honest answer depends on how much rot we find once the old wall comes off. We quote the tear-off, the repair, and the panels as separate lines so you can see where the money goes before you commit.
Highland Square
Older two-story homes with detailed trim and multiple siding layers. We plan extra time for tear-off and trim matching on these elevations.
Firestone Park
Postwar ranches and brick homes with tight lots. Scaffolding access is easy, and most jobs run two to three days.
Merriman Valley
North-facing walls here take the worst of the algae and wind. We correct drainage and flashing before panels go on.
West Akron
Mix of pre-1950 housing with original wood siding. Lead-Safe procedures apply on most of these jobs.
University Park
Rental-heavy blocks where durability matters more than premium profiles. We quote standard and insulated side by side.
Freeze-thaw cycling from December through March
Vinyl expands and contracts hard, so nails must sit centered in the slot with room to move. Tight-nailed panels crack at the nail head within a few seasons.
Lake-effect wind on west and north elevations
Driving rain finds every gap in flashing and caulk. We lap wrap shingle-style and flash windows and doors with trim coil so water sheds instead of soaking in.
Pre-1978 housing stock across most neighborhoods
Painted siding and trim may contain lead. We work EPA Lead-Safe Certified, contain the area, and handle debris properly.
February ice dams at the roofline
Water backs up under soffit and fascia and rots the top of the wall. We inspect that zone on every job and replace damaged soffit in the same pass.
Siding fails in patterns, and Akron weather finds the weak spots fast. These are the calls we get most, and what the fix actually involves.
Problem
Heat escapes through the studs all winter and cold rooms never warm up, so the furnace runs longer and the gas bill climbs every January.
Our Fix
Foam-backed panels add R-2 to R-5 directly against the sheathing and seal air movement behind the wall. Combined with new house wrap, most homeowners see a measurable drop in winter heating cost within the first season.
Problem
Panels that pop off in a gust expose the sheathing to rain, and once water gets behind the wall you are looking at rot, not just a cosmetic repair.
Our Fix
We re-hang the wall with nails centered in the slot so the vinyl can expand and contract without tearing free. Panels lock into the course above and below, and the wall stops shedding pieces every storm.
Problem
The streaks look terrible from the street and hold moisture against the siding, which shortens panel life and feeds the growth with every rain.
Our Fix
New panels with a factory color layer resist algae better than aged vinyl, and we correct the flashing and grading issues that keep that wall wet. Most north-side streaking stops once water drains away from the wall.
Problem
Soft boards invite carpenter ants and rodents, and the damage spreads inward until it reaches framing that is expensive to replace.
Our Fix
Full tear-off exposes the problem while it is still in the sheathing. We cut out rotted wood siding, treat the area, and close the wall with wrap and insulated panels so pests lose their entry points.
Foam-backed vinyl does three jobs at once: it insulates, it seals, and it takes a hit. Here is what that means for a Summit County house that sees four real seasons and a lot of wind.
Lower Winter Heat Loss
The bonded foam adds an insulating layer directly against your sheathing, which slows heat escaping through the studs. Akron homeowners with 2x4 walls and no cavity insulation notice the difference fastest, especially on west-facing rooms that used to run cold all January. Pair it with proper house wrap and you cut air movement behind the panels.
Panels That Stay Put
Loose vinyl siding panels are the number one complaint we hear on older installs, and they usually come from nails driven tight instead of centered in the slot. We hang every panel with a siding nailer and leave the slot free so the vinyl can move. That single detail is why our walls survive a 50 mph November gust without rattling.
Storm and Hail Resistance
Foam-backed panels absorb impact better than hollow vinyl, so hail that dents aluminum siding or cracks thin vinyl tends to bounce off. After a Summit County storm rolls through, we inspect the wall, swap damaged panels, and match the profile and color. You are not re-siding the whole house because of one bad afternoon.
Curb Appeal That Holds
Fading and chalking vinyl siding makes a solid house look abandoned. Modern panels from CertainTeed, Mastic, and Alside carry color that resists UV bleaching, and the deeper profiles read like real clapboard from the sidewalk. That matters at resale on a street where three houses are for sale at once.
Google ★★★★★4.9
Tore off three layers of siding on our Highland Square house and found rot around two windows. Fixed it, wrapped the wall, and had insulated panels up in three days. Upstairs is finally warm in January.
BBB ★★★★★4.8
Handled our hail claim from documentation through installation. The adjuster approved the full elevation and the new panels matched perfectly. No rattling after the next storm.
Google ★★★★★5.0
Quoted the job line by line and stuck to the number. Replaced the north wall siding and soffit, corrected the drainage, and the algae never came back. Straight answers the whole way.
Real experiences from customers who chose our Insulated Vinyl Siding Installation services.
“Our 1928 house had three layers of siding on it and the west wall was cold every winter. The crew tore it all off, found rotted sheathing around two windows, and fixed it before wrapping. Insulated panels went on in three days. The upstairs bedroom finally holds heat, and the trim lines look sharper than anything on the block.”
Dana R.
Homeowner, Highland Square
“Hail took out half our vinyl in one storm and the insurance scope was vague. They photographed every impact, sent it to my adjuster, and got the whole elevation approved. New insulated siding went up the following week and matched the color exactly. No rattling panels after the next windstorm either.”
Marcus T.
Homeowner, Firestone Park
“We had green mold and algae streaking the north side and loose panels popping off in the wind. They replaced the siding with foam-backed panels, redid the soffit, and re-flashed the whole back wall. Two winters later, no streaks, no drafts, and the heating bill dropped about nine percent.”
Priya S.
Homeowner, Merriman Valley
Real answers to the questions we hear most often from local homeowners and property managers.
Full tear-off and rebuild when the old cladding is past patching. If your wall has rot, failed flashing, and faded panels all at once, replacement is cheaper than chasing repairs. We scope it the same way we scope an insulated job.
View Siding ReplacementStandard vinyl when insulation is not the priority and the budget is tighter. Same installation standards, same nail-slot discipline, just without the bonded foam layer. A solid pick for a rental or a garage.
View Vinyl Siding InstallationHeavier, paint-holding fiber cement for homeowners who want a wood look and do not mind repainting every decade. It pairs well with insulated vinyl on a mixed exterior where one elevation faces the street.
View Fiber Cement Siding InstallationCedar and engineered profiles for historic Akron homes where the trim detail has to match the original. We repair rotted wood siding and blend new courses into old so the patch disappears.
View Wood Siding InstallationLP SmartSide and similar products give you a wood texture with better moisture resistance than real boards. A good middle option when you want the look but not the annual upkeep.
View Engineered Wood Siding InstallationWe still repair and replace dented aluminum siding on mid-century homes. When the dents outnumber the good panels, we price a switch to insulated vinyl so you stop patching hail damage every spring.
View Aluminum Siding InstallationCall (330) 567-4711 or email info@apexsidingakronoh.com and we will get back to you the same business day. We answer the phone Monday through Friday, 8 a.m. to 6 p.m., and we check messages Saturday morning. Storm damage after hours? Leave a message and we will call you first thing.
Phone
(330) 567-4711Address
1789 Killian Rd, Akron, OH 44312
Hours
Mon–Fri: 7AM – 7PM
Sat: 8AM – 4PM
Sun: Emergency Only
24/7 Emergency Available